Add Permit(s)

Where am I?

1. Start Work Order
2. Add Permit(s)
3. Measure Load(s)
4. Add Pilots and Drivers
5. Upload to TESS
6. Complete Job

Add each permit required for the Work Order before recording actual measurements on site.

Preferred order:

1. Import permits by email where possible.
2. Enter a permit manually if email import is not available or the imported details need correction.
3. Check and record permit axle measurements.
4. Send permit-side information to TESS from the Work Order screen.

Some Work Orders may have more than one permit. Repeat the permit process until all required permits have been added.

The Permits section on the Work Order screen.

Multiple permits

For each required permit:

1. Add the Permit.
2. Enter the PDF Permit details.
3. Add the Transport Company and regos.
4. Select the Axle Source.
5. Select the axle count or axle configuration.
6. Save.
7. Open the Axle table.
8. Add the axle measurements.

Continue until all permits required for the Work Order have been added.